Adaptive Switch
These are 3D printed switches that can work with any existing device that can accept a switch. It uses a standard 3.5mm headphone plug. Each of these are soldered by hand and tested to confirm accuracy. The cable is approximately 6 feet long, but lengths may vary by an inch.
If you’re interested in a custom design then please contact me!
This original switch design can be found here.
These are 3D printed switches that can work with any existing device that can accept a switch. It uses a standard 3.5mm headphone plug. Each of these are soldered by hand and tested to confirm accuracy. The cable is approximately 6 feet long, but lengths may vary by an inch.
If you’re interested in a custom design then please contact me!
This original switch design can be found here.
These are 3D printed switches that can work with any existing device that can accept a switch. It uses a standard 3.5mm headphone plug. Each of these are soldered by hand and tested to confirm accuracy. The cable is approximately 6 feet long, but lengths may vary by an inch.
If you’re interested in a custom design then please contact me!
This original switch design can be found here.